Hey guys

I would like to know how I can take off the silver surrounding that goes under the factory shift ****, because it looks very weird with a ring under my new ball shaped shift ****...

Also, how do you guys make the shift boot stand up? Currently i have electrical tape wrapped around the shaft but was wondering if there's a less ghetto way to do that.

 

You know I'm a moron and couldn't figure this out either.

I just put the factory back on until I could figure it out. Lol.

 

I have a light spring under the shift boot to keep it, eh.., erect.

 

I'll try to be creative and rip that silver thing off

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by smk &raquo;</TD></TR><TR><TD CLASS="quote">

I'll try to be creative and rip that silver thing off</TD></TR></TABLE>

remove your whole center console, turn it upside down, and the silver thing is attached by a ziptie, use a knife or scissor to cut it off.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by smk &raquo;</TD></TR><TR><TD CLASS="quote">Hey guys


Also, how do you guys make the shift boot stand up? Currently i have electrical tape wrapped around the shaft but was wondering if there's a less ghetto way to do that.</TD></TR></TABLE>

A large ziptie works great

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by pon55 &raquo;</TD></TR><TR><TD CLASS="quote">A large ziptie works great </TD></TR></TABLE>

a large black ziptie lol