I currently have a b16a2 in my hatch with a turbo kit.I was going to start building the bottom end of this LS motor I had around my shop I wanna throw some pistons and rods in it and probley just a block gaurd since i can't afford sleeves.What compression ratio should I use knowing my b16 head will bump it up .3.I was planning on going with cp pistons and eagle rods.Any advice on my buildup will be appreciated.

 

sounds like a decent way to go. im doing the same thing but not cp, to expensive, hehe. 9.1 ls pistons will be about 9.5 almost with a b16a head.