intake material source for GT42R?
08-01-2007, 10:51 AM
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2004
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
intake material source for GT42R?
does anyone know where you can get lightweight polished aluminum 5" mandrel bends? We're trying to get an intake made for a 42R application but all of our mandrel bend sources only sell to 4". I really dont want to use steel mandrels for an intake bc 1)it will not look the same as the rest of the system and we're **** like that and 2)it will be heavy as hell.
This might be a ghetto question but has anyone put a 4->5 adaptor on the comp inlet on the 42R and ran a 4" intake setup? Would this reduction in intake diameter compromise hp at all? Thanks
This might be a ghetto question but has anyone put a 4->5 adaptor on the comp inlet on the 42R and ran a 4" intake setup? Would this reduction in intake diameter compromise hp at all? Thanks
08-01-2007, 05:59 PM
#4
Honda-Tech Member
Thread Starter
Join Date: Jul 2004
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Re: intake material source for GT42R? (dturbocivic)
can you all PM me a price on a 45 degree bend in 5", the radius, and whether or not its polished or raw aluminum. I assume this is 16ga as well?
lastly, PM a price on a foot of 5" alum straight and again if its raw or polished. wall thickness on the straight section too please. thanks for your time
lastly, PM a price on a foot of 5" alum straight and again if its raw or polished. wall thickness on the straight section too please. thanks for your time
Thread
Thread Starter
Forum
Replies
Last Post