IC Piping vs. IM height
03-30-2008, 12:13 PM
#1
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: Mar 2004
Location: Geneva, FL, USA
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
IC Piping vs. IM height
Alright i have tried searching this but couldnt find a clear answer.
I am just finishing up my Engine build for my new turbo setup. I will have a fully built GSR bottom end w/ a Built B16 head. Now i am getting ready to order the Intercooler piping. My setup will be going into a DC integra chassis and i am wondering Because i am using an Edelbrock IM for a B16 head, will the IM sit higher, lower or at the same height as a stock GSR manifold. I want to order piping but want to make sure it will meet up w/ the IM at the right height. Any input to the height difference or similarity would be appreciated . TIA
I am just finishing up my Engine build for my new turbo setup. I will have a fully built GSR bottom end w/ a Built B16 head. Now i am getting ready to order the Intercooler piping. My setup will be going into a DC integra chassis and i am wondering Because i am using an Edelbrock IM for a B16 head, will the IM sit higher, lower or at the same height as a stock GSR manifold. I want to order piping but want to make sure it will meet up w/ the IM at the right height. Any input to the height difference or similarity would be appreciated . TIA
Thread
Thread Starter
Forum
Replies
Last Post
sactocivic
Forced Induction
4
03-24-2006 03:53 AM
