B20-T

i have a automatic p28 ecu..can u rechip it to 5speed specs?or is there any way i can convert it to 5speed from auto?

red_sir

Yeah, it can be chipped to manual specs.

eg6turbo

u dont have to technically chip it...u can do it for free by urself...im not sure if its good or not but i ran with a auto p28 on my d15b everything werks no CEL light for auto lock tq....its simple..
heres a pic

on the lower left side u will find a series of resistors...its outlined in white in the pic...the rectangle area...its label very tiny but all u have to do is cut P17....there should be a lil resistor on there...thats it....plug it in and see if it werks...it werked for me...took 1 sec and ur done....

swrdply400mrelay

eg6turbo

yes i kno that there are those black packets there and shows that if its auto or not...but i just cut P17 and it werked for me...im just saying what u have to lose...trust me on this cut p17 and ur good...

swrdply400mrelay

Damn, I wish I found this out sooner, I sent mine in to be converted for $20.

Oh well, when I get it back I can at least confirm.


[Modified by swrdply400mrelay, 10:39 PM 2/23/2003]

sparkz

cut rp17, and jumper rp18

eg6turbo

yeah i would mention that jumper but there is a resistor on there already that proved not to cause any probs overall...

swrdply400mrelay

Why did you cut rp18? I got mine converted and rp18 wasn't cut. But when I start my car, I have to prime it for about 10 secs and give it gas for a few secs before it will idle. If I don't, the car will die.

Spunkster

removing rp17 and jumpering rp18 is the correct way to do it.