Hey guys Wana make this short,

i just finished my head install today and forged rods plus pistions, I went to start the car but it wouldn’t start and instead would only crank. It’s 2 am and I need the car running tomorrow as I need it for work.

i noticed that ground wire from tranny to body gets hot and starts burning noticed it as it started smoking, also have tried flipping over the dizzy rotor just to see if it was that but nah.

what I did that may have chased it:
HEAD SWAP as last head had striped bolt holes
forged pistions
forged rods — no notch rods

have done timing.

 

Sounds like some sort of wiring/ground issue. But dude, turning your daily into a race car is a recipe for walking to work.