Complete n00b question about header flange
#1
Member
Thread Starter
Complete n00b question about header flange
What is the exhaust port spacing on the D-series and B-series engines? I have a flange for one of the two, that is about 3-3/8" center-center, and need to know which one it is.
Thanks!
Thanks!
#2
Member
Thread Starter
Re: Complete n00b question about header flange (beepy)
Nevermind. I dug up some old CAD files and figured out it was a B-series.
Modified by beepy at 1:43 AM 7/24/2004
Modified by beepy at 1:43 AM 7/24/2004
#3
Member
Thread Starter
Re: Complete n00b question about header flange (beepy)
OMG, I'm such an idiot.
I did in fact use a Honda B-series flange for my Kia manifold. But Turbopimp gave me the information I was after to begin with, in port spacing:
D-Series: 85mm - 85mm - 85mm
B-Series: 90mm - 80mm - 90mm
Kia flange: 86mm - 86mm - 86mm
So I should have built my Kia header with a D-series flange. I would have been .5mm off on the inner ports and 1.5mm off on the outer ports, which isn't even the thickness of the piping. Instead I had to make nasty gap welds and didn't know any better. Oh, well, live and learn.
I did in fact use a Honda B-series flange for my Kia manifold. But Turbopimp gave me the information I was after to begin with, in port spacing:
D-Series: 85mm - 85mm - 85mm
B-Series: 90mm - 80mm - 90mm
Kia flange: 86mm - 86mm - 86mm
So I should have built my Kia header with a D-series flange. I would have been .5mm off on the inner ports and 1.5mm off on the outer ports, which isn't even the thickness of the piping. Instead I had to make nasty gap welds and didn't know any better. Oh, well, live and learn.
Thread
Thread Starter
Forum
Replies
Last Post
alexsracing
Forced Induction
2
02-12-2007 08:19 PM
Da1spaz247
Welding / Fabrication
3
04-14-2006 10:19 AM