Code 1,2,7 and no fuel pressure???
Thread Starter
Joined: Jul 2004
Posts: 738
Likes: 0
From: Raleigh, NC, USA
Code 1,2,7 and no fuel pressure???
Before I start I drive a pr3 b16 that I just turboed. Running the program BRE.
Story: On the way home today I arrived at a stop light and my car died on me.Im like "WTF". So I turned her over a few times and boom...shes running. So I nail it and she dies at the next light after that. Bump her over and drove across the road and once again cut off. At that time I was in a parking lot. I looked at the ECU and I saw code 2. I have my o2 sensor disabled on my chip so im like What???. Then she threw a code 7(tps sensor) I highly doubt that my tps sensor is bad. She read 5v. Code 1 I forgot what it was but all in all she would not start. After contiplating I noticed that the fuel pressure gauge on my filter had dropped to like 20. Then after about 30 minutes to about 15. 30 after that to 0. So im thinking its my fuel pump but then again its a new 255 walbro. Any suggestions.
Story: On the way home today I arrived at a stop light and my car died on me.Im like "WTF". So I turned her over a few times and boom...shes running. So I nail it and she dies at the next light after that. Bump her over and drove across the road and once again cut off. At that time I was in a parking lot. I looked at the ECU and I saw code 2. I have my o2 sensor disabled on my chip so im like What???. Then she threw a code 7(tps sensor) I highly doubt that my tps sensor is bad. She read 5v. Code 1 I forgot what it was but all in all she would not start. After contiplating I noticed that the fuel pressure gauge on my filter had dropped to like 20. Then after about 30 minutes to about 15. 30 after that to 0. So im thinking its my fuel pump but then again its a new 255 walbro. Any suggestions.
Thread
Thread Starter
Forum
Replies
Last Post