I was looking for your guys take on these injectors, 270-310cc's. I will be looking for a nice set of injectors for my LS-VTEC set up and wanna know how they have been performing for you, if there easy to install. Im lacking most of my power due to the fact that i am not receiving enough fuel to power my new engine, By the way, its a fully rebuiult bottom end, Endyn pistons rings bearings Eagle rods, bored honed and decked, with a b16a head Also, the Classified forum is not allowing me a post, but i am really interested in purchasing a set of these and wanted to know where you got yours from, how much, if theres anyone on here to talk to, and the best place to go to get these, Thanks for your help
Phil

 

You could also pick up some 94-96 VTEC 'lude injectors (310cc's)for $50 and send them to RC for blueprinting and cleaning. Same quality and for a FRACTION of the cost. If I remember correctly, RC charges $25 per injector, so your gonna come out good.

Answer to post below (because HT wont allow me more than 5 posts per 24hr): I'm about to send my 450 DSM's to them. Their website will say a general turn around period.

I believe its only one or two days plus shipping time.


Modified by blackknightgsr at 12:46 AM 4/30/2003

 

How long would this process take? Have you ever done this before?