Hi,

with my B16 i want to run CTR pistons, and eagle rods but how much would i have to shave off the rods for the pistons to fit or shave off the pistons for the rods to fit?

and would this setup be "reliable" with a 100 shot of NX direct port? timing retard when spraying. and fuel precautions taken.

let me know your opinions. thanks (if you think it's stupid let me know i got my flame proof suit on )
-scottie

 

I belive you have to remove 1mm from each side of the piston where the wrist pin bore is.

 

yeah but would it still be 1mm with the eagle rods also?

 

Probably. If the Eagles are designed to replace stock then they're probably similar width. I didn't have to shave ITR pistons to attach to Eagle GSR rods, but I think yours will be wider on the small end.

 

well thos rods are b18 i'm a b16.....

ehhh i'll just save up a bit more and get some ross

thanks