spiderrey

Im installing a honda engine into a non honda car. The engine and trans fit pretty well. I was thinking of going to the pick a part and cut the factory mounts out of a honda. Then rig them up to my driveline and reset everything into my car. my thoughts are I might be able to modify and strenghten these mounts to get this driveline installed. Is this lame ,is there an easier way. looking for any and all opinions.

spiderrey

A bit surprised no one has an opinion on this. Maybe I came to the wrong place. Thanx Reyy

intense4thgen

looks to me that your on the right track but id use a 1/8 plate and build your own mounts rather then use the Honda ones. just to clarify ( keep the mounts bolted to the motor) and make the mounts to the chassis

spiderrey

Thanx, I just thought if I had the stock mounts it might help me design new ones since Ive never done this.