JDM GSR swap into LS wiring question
#1
JDM GSR swap into LS wiring question
So I'm planning to swap a JDM b18c1 into my USDM 94 LS which currently is running a obd2 LS motor.
Will the sensors and harness be the same and work? and will the usdm ecu work fine?
Will I have to make some wiring modifications other than wiring vtec?
Will the sensors and harness be the same and work? and will the usdm ecu work fine?
Will I have to make some wiring modifications other than wiring vtec?
#2
Technical Hero
Join Date: May 2002
Location: Charlotte, NC, 28227
Posts: 9,876
Likes: 0
Received 28 Likes
on
20 Posts
Re: JDM GSR swap into LS wiring question
You should be fine wiring wise as long s the B18C1 is OBD1. For the LS did you use and OBD1 distributor, injectors and alternator? You'll have to wire VTEC, knock sensor and the IAB's. The USDM ECU will work fine.
Thread
Thread Starter
Forum
Replies
Last Post