will Tein pillow ball top hats (PRH08-31S70) fit on Skunk2 proC?
10-07-2014, 06:40 PM
#1
Honda-Tech Member
Thread Starter
will Tein pillow ball top hats (PRH08-31S70) fit on Skunk2 proC?
so I was at the racetrack, in my 95 integra late in the session and I spin out on a 100+mph left turn, thankfully nothing happened but I did realize my right top mount bushing was completely gone, all my rubber bushings are replaced with spherical bearing, this was the last rubber part on the car, this calls for an upgrade! so I want to know if anyone can help. will the Tein part fit?
Last edited by alexeghatch; 10-08-2014 at 03:28 AM.
10-14-2014, 02:17 PM
#2
Honda-Tech Member
iTrader: (1)
Join Date: Nov 2007
Location: progress starts now.
Posts: 1,518
Likes: 0
Received 6 Likes
on
5 Posts
Re: will Tein pillow ball top hats (PRH08-31S70) fit on Skunk2 proC?
If Tein and Skunk are using the same sized shaft then they should work.
If the Tein mounts are larger then you can use a misalignment spacer with different diameter to make it fit. I used a mix-matched setup like this before using Apex upper mounts.
If the Tein mounts are larger then you can use a misalignment spacer with different diameter to make it fit. I used a mix-matched setup like this before using Apex upper mounts.
Thread
Thread Starter
Forum
Replies
Last Post
Sparco_TypeR
Acura Integra Type-R
1
03-22-2004 08:13 PM
sleepyhamsterlx
Honda Civic / Del Sol (1992 - 2000)
2
08-31-2003 06:43 PM