Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 2
1
2
Search: Posts Made By: khooper
Showing results 1 to 25 of 31
Search took 0.40 seconds.
Forum: Honda Prelude
02-06-2009, 02:07 PM
Replies: 9
Views: 860
Posted By khooper

Re: Power Steering Pump

It seems to be common practice to use Transmission Fluid for power steering.Is this suitable??
___________________
import parts (http://www.1motormart.com/) lover
Forum: Acura Integra Type-R
11-10-2008, 03:11 PM
Replies: 28
Views: 2,421
Posted By khooper

Re: (Hooch'n)

My Halloween this year is not as good as the previous because my car was broken. Good thing is I have found an Autopartswarehouse Halloween Promo...
Forum: Honda Accord & Crosstour (2003 - 2012)
10-03-2008, 05:54 PM
Replies: 5
Views: 803
Posted By khooper

Re: lowering my accord (chinoloco 03 accord)

a cheap way would be to hack the springs, any mechanic can do that pretty cheap and the absorbers and that can stay stock. may it could also jncrease gas mileage...
Forum: Honda Accord & Crosstour (2003 - 2012)
09-23-2008, 07:32 PM
Replies: 5
Views: 847
Posted By khooper

Re: 2004 Accord V6 not starting? (teqp)

have you checked the starter. it could be the issue or a bad ground. Follow your ground from the bat., and check your main ground. yeah they're right better see a mechanic.
______________________...
Forum: Honda Accord & Crosstour (2003 - 2012)
09-19-2008, 07:14 PM
Replies: 2
Views: 905
Posted By khooper

Re: Disconnect ABS (honda53008)

sounds like your brake booster isnt working properly, no vaccum assist at all? is it impossible to put down the pedal? or is it like old manual brakes on the older vehicles?...
Forum: Suspension & Brakes
08-27-2008, 11:12 PM
Replies: 7
Views: 2,587
Posted By khooper

Re: Which grease? (Mr.EM1)

Lithium grease and Marine grease are all petroleum based. Any petroleum based grease will react and degrade your bushings including Polyurethane bushing and stock OEM rubber Bushings. They may work...
Forum: Honda S2000
08-26-2008, 09:59 PM
Replies: 6
Views: 3,567
Posted By khooper

Re: S2000 clutch (redLUDEs2k1)

Yes, you are slipping the clutch, but this is perfectly normal for a manual car when positioning a car at low speed. As others have said dropping the clutch at high revs is much more damaging.
...
Forum: Tech / Misc
08-26-2008, 09:21 PM
Replies: 1
Views: 379
Posted By khooper

Re: brake light problem. (98integralsB18)

You can check the brake switch. It's attached to the brake pedal assembly under the dash. Unplug the switch and use a wire to jump the two pins. If the lights turn on it's the switch....
Forum: Honda Accord (1990 - 2002)
08-26-2008, 09:14 PM
Replies: 4
Views: 525
Posted By khooper

Re: car makes loud scracth noise when trying to start...help (anthonygauna)

Possibly the throw out bearing has failed, however, on further thought there are a couple of items to check. The starter bendix could have failed or possibly the ring gear on your flywheel....
Forum: Tech / Misc
08-19-2008, 10:19 PM
Replies: 2
Views: 466
Posted By khooper

Re: starting problem: pgm fi relay? (4XmattX2_0X)

Could be a bent wheel rim. if you hit a pothole, anything is possible, depending on how hard you hit the pothole.

Take tire and wheel to a tire shop. they have a maching that can spot the problem,...
Forum: Tech / Misc
08-19-2008, 10:05 PM
Replies: 2
Views: 892
Posted By khooper

Re: aluminum vs. titanium (BILLETGRIP)

an aluminum valve spring retainer which is lighter and less costly than titanium retainers of approximately equivalent strength.
_____________________________
Autopartswarehouse...
Forum: Honda Prelude
08-13-2008, 05:32 PM
Replies: 3
Views: 379
Posted By khooper

Re: car wont run right wen drivin help urgently (robby86)

It would seem that you have various electrical problems and it would do no harm working through all connections and refreshing them with particular attention to the earth straps on the engine and...
Forum: Honda Accord & Crosstour (2003 - 2012)
08-13-2008, 05:22 PM
Replies: 2
Views: 543
Posted By khooper

Re: 03 Accord LX transmission problem? (tz12789)

If it's making a slight gear noise while driving it's because of the shifter and that's normal when you install an aftermarket shifter because the aftermarket shifter is not insulated like the stock...
Forum: Honda CRX / EF Civic (1988 - 1991)
08-08-2008, 08:20 PM
Replies: 18
Views: 711
Posted By khooper

Re: Changed fuel filter now no idle (wesleywhite989)

Make sure it is getting the proper air flow. Is the intake duct sealed. The fuel pump good. My dad had a problem with his catalyst converter not getting the proper air and now it wont go over 25....
Forum: Honda Accord & Crosstour (2003 - 2012)
08-06-2008, 10:12 PM
Replies: 3
Views: 1,544
Posted By khooper

Re: Coilovers on stock struts.. (kpjo4)

Been running maxspeed springs with stock shocks on my 2003 for a year now with no problems. I just don't know why almost everyone seems to think that stock struts/shocks will blow very shortly after...
Forum: Forced Induction
07-30-2008, 05:36 PM
Replies: 1
Views: 1,247
Posted By khooper

Re: Oil leak on turbo'd d17 (kenbo21)

As the gasket gets older it shrinks, try to tighten the bolts before you take them down again. Also, your real main seal could be leaking if the oil is coming out of your clutch cover inspection...
Forum: Tech / Misc
07-30-2008, 05:27 PM
Replies: 3
Views: 446
Posted By khooper

Re: wierd power loss...vtec works, fp is good....thoughts? (meallout)

Check your vacuum hoses usually they cause the problems described and the crap out anywhere in between 50 to 100 thousand kilometers. Also try to clean fuel tank pump filter.
______________________...
Forum: Tech / Misc
07-30-2008, 05:15 PM
Replies: 3
Views: 747
Posted By khooper

Re: Rocker Shaft help (civic_66)

The greatest difference between the intake and exhaust ports would have to be the evolution from the standard 13B-REW to the RENESIS engine. Try checking this link https://honda-tech.com/zero...70698...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-28-2008, 09:24 PM
Replies: 6
Views: 396
Posted By khooper

Re: (vtec_ef8)

Could be the relay or fuse. I would check the ground wires as well located below the battery too. To avoid getting worse better bring your car in the mechanics. And always be sure that your car parts...
Forum: Tech / Misc
07-22-2008, 06:17 PM
Replies: 3
Views: 489
Posted By khooper

Re: lsd problems. (antivic)

maybe the reason it happens is that because the engine is off and LOCKING the center.
The differentials allow the wheels to spin at different speed.
Without the differentials, your tires would...
Forum: Suspension & Brakes
07-22-2008, 06:10 PM
Replies: 4
Views: 537
Posted By khooper

Re: sqeaking shock (LudeJdm)

Its probably your bushings. Unbolt it and clean those out and apply fresh grease like Slick Honey. If its the air shock, let all the air out and unscrew the air sleeve. Clean all that stuff up and...
Forum: Tech / Misc
07-15-2008, 05:31 PM
Replies: 3
Views: 684
Posted By khooper

Re: Knock Sensor Question (wrestler72)

the cars connector or wiring is probably damaged. If you have replaced the knock sensor, then defenitely reset your ECU. Once that is complete, you should have full power almost immediately....
Forum: Tech / Misc
07-15-2008, 05:17 PM
Replies: 4
Views: 509
Posted By khooper

Re: Transmission issues... (DrewMD)

I had the same problem, and according to a tech bad motor mounts will cause strain on the shift linkage and 5th gear assy to wear out prematurely. Causing the dreaded 5th gear pop out. ...
Forum: Honda Accord & Crosstour (2003 - 2012)
07-15-2008, 04:56 PM
Replies: 44
Views: 229,144
Posted By khooper

Re: can't shift out of park (dsjetergirl)

I am no mechanic, but I honestly think that this is your problem. I believe you can remove the collar and console from around the gearshift itself and physically see the lock engaging and...
Forum: Tech / Misc
05-26-2008, 07:14 PM
Replies: 7
Views: 519
Posted By khooper

Re: overheating prob!!! (boostedcivic37343)

this might help you distinguish the cause of the overheating.

the temperature gauge will swing back and forth until the entire system is warmed fully. This is because you keep introducing "cold"...
Showing results 1 to 25 of 31
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -8. The time now is 09:49 PM.