Notices
 
Search: Posts Made By: got_no_sol
Showing results 1 to 25 of 267
Search took 0.59 seconds.
03-31-2017, 07:11 PM
Replies: 8
Views: 973
Posted By got_no_sol

Re: I may be in over my head with this build

You don't need pics just read and folllow directions , get a pin out , solder gun , hear shrink , and go to town it seems intimidating but it's really simple , you only wiring in 4 wires on the...
03-31-2017, 06:32 PM
Replies: 0
Views: 992
Posted By got_no_sol

Is my fuel pump bad or something else?

I have a 91 honda civic (LX Sedan) drove my car yesterday and everything was fine. Went to start it up today and it wouldn't start and the fuel pump doesn't hum. I have replaced the main relay with a...
03-24-2017, 11:48 AM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

I have done all the above stated , I'm still throwing ivac code and it tested fine on the multimeter although the car is running better a new problem has developed , if you "rev" the car and let of...
03-24-2017, 11:36 AM
Replies: 13
Views: 7,005
Posted By got_no_sol

Re: 4 wire 02 help

Ok I have fixed the vacume leak , the car will warm up and idle fine sometimes it will hunt , but will eventually settle around 1k -800 , now the issues are as follows , if rev the car and let off...
03-24-2017, 03:23 AM
Replies: 7
Views: 3,487
Posted By got_no_sol

Re: Throttle body shaft seals ????

We were checking for vacume leaks , it's leaking right behind the spring a small shot of starting fluid in the spring and idle goes crazy for a second
03-23-2017, 06:40 PM
Replies: 13
Views: 7,005
Posted By got_no_sol

Re: 4 wire 02 help

1,14,22. Sometimes 7 or 9 but not consistent , I fixed the rich issue and found I have a vacume leak on my throttlebody shaft seal and fitv will address those tmrw , I have a bouncing idle untill the...
03-23-2017, 06:30 PM
Replies: 7
Views: 3,487
Posted By got_no_sol

Throttle body shaft seals ????

I've found out I have a leaking seal behind the throttle cable mount is this a replaceable seal ? Or does anyone have a fix for this ??
03-23-2017, 07:50 AM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

Nvm I had the ivac plugged into the intake temp sensore , give me a few I'll see if that fixes the problem and report back
03-23-2017, 07:33 AM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

I have 3 two wire sensors the one I have on my ivac is white plug , black/yellow and orange wires if I plug it in or un plug it nothing changes ,but the ground on that plug has continuity and the...
03-23-2017, 06:12 AM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

https://m.youtube.com/watch?feature=youtu.be&v=Oof-40OIPfk

this is what my idle is doing untill the car warms up which takes forever I'm currently waiting on fuel to get here to continue on
03-23-2017, 04:39 AM
Replies: 5
Views: 911
Posted By got_no_sol

Re: B16B (Type R) fit 91' crxsi w/o mods?

If you bought a full swap and I mean full swap you'd really only need mounts , limkage , and wiring
03-23-2017, 03:31 AM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

I know how they come apart , I was asking how am I supposed to keep rhem in the rail while spraying into the bucket 38-50 psi seems like it will push them out
03-22-2017, 05:21 PM
Replies: 20
Views: 8,619
Posted By got_no_sol

Re: 96 civic 1500 rpm bounce

Remove intake start the car , then stuck your finger over the bypass hole in the tb if the idle corrects it's self , adjust the fitv
03-22-2017, 04:22 PM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

Compression is good , I just changed the plugs I'll check them tnrw , I'm starting to think injector also , how would spray them into a bucket without them Comjng off the rail
03-22-2017, 02:55 PM
Replies: 14
Views: 1,142
Posted By got_no_sol

Re: Someone figure this out please !

The car doesnt run badly that's what's got me fucked it runs like a champ pulls hard ,etc , I just have a bouncing idle between 1500/1800 rpm untill it warms up and the it drops down to like 8-900...
03-22-2017, 12:21 PM
Replies: 14
Views: 1,142
Posted By got_no_sol

Someone figure this out please !

Ok I've got a b16 swap in a ef (yes I know this is the eg thread but ef side is no help and I'm obd1) the car is running very rich smoking ect , the car is throwing code 1, 14, 22 , I'm not...
03-22-2017, 10:17 AM
Replies: 13
Views: 7,005
Posted By got_no_sol

Re: 4 wire 02 help

You still around ? I've wired in a new Bosch o2 and I'm still running rich and throwing code I've followed the above with two o2 sensors and to no avail .. Any ideas ?
03-19-2017, 01:50 PM
Replies: 0
Views: 613
Posted By got_no_sol

Slow idle surge?? (Video)

What do you guys think this is?
https://youtu.be/ozDkpTdgnsk
03-14-2017, 07:13 AM
Replies: 675
Views: 65,622
Posted By got_no_sol

Re: Marcos's new work car 90 sedan

Ok just a heads up man that header is going to scrap on everything they hang to low for ef chassis , you have to cut the xmenber to clear almost every header out there , if your worried about...
03-13-2017, 12:23 PM
Replies: 49
Views: 36,194
Posted By got_no_sol

Re: DPFI To MPFI conversion

a multimeter is about to be your best friend
03-13-2017, 11:13 AM
Replies: 3
Views: 1,485
Posted By got_no_sol

Re: Interchangeable parts questions

I'm nit trying to throw s wrench into the above reply but I personally without a doubt used sk2 Uca's from a eg on a ef
03-13-2017, 07:28 AM
Replies: 2
Views: 802
Posted By got_no_sol

Re: Am I reading codes right (video)

Ok the 02 I knew I'm trying to fix that now , the vtec works fine so idk why that code is throwing , sometimes I get five fast flashes and sometime 3 fast flashes but after resetting the ecu those...
03-13-2017, 07:21 AM
Replies: 13
Views: 7,005
Posted By got_no_sol

Re: 4 wire 02 help

It's refusing to read my o2 ( possibly have a bad 02) does the o2 ground need to go to the ecu or can I ground it in the bay ? Cause that pin on my ecu is being used and I don't really have a decent...
03-13-2017, 06:50 AM
Replies: 2
Views: 802
Posted By got_no_sol

Am I reading codes right (video)

Can someone just confirm I'm reading these codes right ? I believe it's code 1-2 o2 sensor https://m.youtube.com/watch?v=isukPGD4laE&feature=youtu.be
03-13-2017, 05:15 AM
Replies: 11
Views: 3,044
Posted By got_no_sol

Re: 89 LX Sedan dies after changing alternator

Check the ignition switch next time it does jiggle the fuck out of the key and see if it will start or do the reverse while running jiggle and try to make it shit off , I had a near identical issue...
Showing results 1 to 25 of 267
 


 
Forum Jump


All times are GMT -8. The time now is 04:35 PM.