Notices
 
Search: Posts Made By: andyc_0652
Showing results 1 to 25 of 29
Search took 0.43 seconds.
11-18-2010, 05:19 PM
Replies: 8
Views: 5,348
Posted By andyc_0652

Re: b16 code 7(tps). new tps, still a code

I've done that in the past, but it wouldn't hurt to check again. What else would cause surgin idle other than iacv, tps, vacuum, or coolant?


It will idle fine on a cold start is the weirdest...
11-17-2010, 12:02 PM
Replies: 8
Views: 5,348
Posted By andyc_0652

Re: b16 code 7(tps). new tps, still a code

Found the source of the tps code...there was a loose wire that needed some attention...got rid of the code!!! But now the idle is fine until the engine gets up to normal operating temp and it gets to...
11-17-2010, 09:31 AM
Replies: 8
Views: 5,348
Posted By andyc_0652

Re: b16 code 7(tps). new tps, still a code

Didn't calibrate the new tps...was hoping it would be a quick fix. I'll have to wait on a multimeter to check voltage.
11-16-2010, 09:41 PM
Replies: 8
Views: 5,348
Posted By andyc_0652

b16 code 7(tps). new tps, still a code

Finally got past the surging idle of 1k-2k, by replacing the iacv, now i get code 7 (tps). just got a factory new tps, put it on, reset the ecu by pulling the backup fuse from the engine bay, and i...
10-18-2010, 11:37 AM
Replies: 2
Views: 1,205
Posted By andyc_0652

Re: Another b16 Idle Thread. (I've searched..)

rough idle as in variating between 1k-3k for maybe 10 mins everytime i slow down to an idle, then being normal.
10-18-2010, 11:21 AM
Replies: 2
Views: 1,205
Posted By andyc_0652

Another b16 Idle Thread. (I've searched..)

I've searched the other forums and still haven't found a resolution to my problem, so here goes...

I've had a rough idle on my b16 civic for about a year now. I'd clean the IAC every time it got...
10-05-2010, 04:49 PM
Replies: 6
Views: 3,713
Posted By andyc_0652

Re: 00 Civic ex won't rev over 4k rpm and has rough idle

I'm no expert, but my car does this when there is a lot of moisture outside and my diagnosis was the ECU going into "limp mode." Still haven't resolved my problems either...
Forum: Honda / Acura
08-30-2010, 08:29 AM
Replies: 3
Views: 1,106
Posted By andyc_0652

Forum: Honda / Acura
08-30-2010, 08:06 AM
Replies: 3
Views: 1,106
Posted By andyc_0652

long mirrors on civics terminology...

I've seen them on several cars on here and have searched for a little while. Whats the right terminology for those rear view mirrors that go from pillar to pillar??
08-18-2010, 10:55 AM
Replies: 6
Views: 958
Posted By andyc_0652

Re: B16a catalythic converter 0/2 ??

yeah, i guess i should have mentioned its an obd1 setup. i was hoping to find one i could bolt on myself, so @del namco solo magnaflow?
08-18-2010, 09:49 AM
08-18-2010, 08:17 AM
Replies: 6
Views: 958
Posted By andyc_0652

Icon6 B16a catalythic converter 0/2 ??

Currently running a test pipe out of a b16a civic with a skunk2 megapower and OBX header. Next step in my car is to replace header and I was thinking of adding a cat because the new city I'm in...
08-13-2010, 10:20 AM
Replies: 6
Views: 951
Posted By andyc_0652

Re: B16A Header opinions/brands

Just moved to a new town idk if emissions are an issue.. I hope not because i'm running a test pipe
08-13-2010, 08:02 AM
Replies: 6
Views: 951
Posted By andyc_0652

Re: B16A Header opinions/brands

@deetz- yeah, power-wise anything would be better than what I have currently (OBX)..a beat up and nearly creased one at that. I've found a ceramic coated dc on ebay for like 300 shipped, i just don't...
08-13-2010, 07:55 AM
Replies: 6
Views: 951
Posted By andyc_0652

B16A Header opinions/brands

Currently running an em1 with a b16a, aem short ram, and skunk2 mega power..

destroyed my header the other day and was looking for some insight on brands..i want a dc sports but megan is more in...
Forum: Want to Buy
08-12-2010, 06:10 PM
Replies: 5
Views: 551
Posted By andyc_0652

Re: WTB B16A 4-1 header

yeah i'm pretty set on the 4-1 man. thx though
08-12-2010, 06:09 PM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

cleaned iac, bled coolant, and reset ecu. no code and no rough idle! THANK GOD.

i'm so relieved..

now the the exhaust leaks....haha thx for the help guys
08-12-2010, 04:21 PM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

jumped the service connector and the cel just stays constant. but quick question: when you unplug the iac and the idle is ffixed but still throws a code, what does that mean?
Forum: Want to Buy
08-12-2010, 06:42 AM
Replies: 5
Views: 551
Posted By andyc_0652

WTB B16A 4-1 header

preferrably dc... but I can't handle this leak much longer. Will pay to have it shipped to TX.
08-12-2010, 06:32 AM
Replies: 11
Views: 12,144
Posted By andyc_0652

Re: another fluctuating idle thread - 95 civic ex

GL man, having similar probs myself. I removed and cleaned the TB on my setup and it made it slightly better but still very obvious.
08-12-2010, 05:57 AM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

hha word. flushed it out and still no change...but get this. I've noticed that it'll have the lumpy idle but when I switch the A/C on it will idle normal??
08-11-2010, 01:27 PM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

I'm going to try to bleed the coolant system when I get off work, anyone have any write-ups or pics on where I should bleed out of the thermostat?
08-11-2010, 08:40 AM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

Excellent write up, but currently it's not throwing a cel.
08-11-2010, 08:28 AM
Replies: 11
Views: 1,314
Posted By andyc_0652

Re: B16A Idle probs + others

Well when the code was on constant, i took it to autozone one day and they were unable to read the code, my guess is because of the obd2->1 ecu. I don't have access to a factory ecu atm.
08-11-2010, 08:06 AM
Replies: 11
Views: 1,314
Posted By andyc_0652

B16A Idle probs + others

I know this topic has been beat to death, but humor me...

My B16a EM1 Civic has an idle pulsing from 1k-2k. When it rains, it goes into limp mode not reaching above 2500k. After the cars been on a...
Showing results 1 to 25 of 29
 


 
Forum Jump


All times are GMT -8. The time now is 08:24 AM.