Notices
Search: Posts Made By: iang
Showing results 1 to 6 of 6
Search took 0.51 seconds.
02-16-2011, 04:16 PM
Replies: 35
Views: 19,950
Posted By iang

Re: Cant break loose crank pulley nut.

I have seen several videos where pros used an oxy-acetylene torch and then blasted it off with an impact. I cant believe you got it with an electric impact.

The 900 ft-lbs doesnt seem that...
02-16-2011, 08:53 AM
Replies: 35
Views: 19,950
Posted By iang

Re: Cant break loose crank pulley nut.

Well after 105K miles, it takes way more than 181 ft/lbs to break it free. I have a V6 and used the starter bump method to break it free(wont work on your 4 cyl I dont think) because I couldnt get...
01-25-2010, 02:24 PM
Replies: 33
Views: 11,763
Posted By iang

Re: Crank bolt removal-HELP!

The bar would most likely break at the pivot so most likely nothing bad would happen otherwise the bar would probably fall off the bolt. I agree though it might not be pretty but I have yet to hear...
01-22-2010, 03:53 PM
Replies: 33
Views: 11,763
Posted By iang

Re: Crank bolt removal-HELP!

I did the starter blip method to get it off. I tried to get it off with the extensions and puller holder tool but everything was flexing way too much. I actually think the starter method might...
05-22-2008, 05:47 AM
Replies: 3
Views: 2,735
Posted By iang

Re: Slow start on 2000 Accord Ex V6 (02 accord)

I changed the spark plugs at 105K (now at 115K) so they should be fine. I recently changed out the timing belt, water pump, and drained the coolant. The car only takes a while to start if it has...
05-20-2008, 07:27 PM
Replies: 3
Views: 2,735
Posted By iang

Slow start on 2000 Accord Ex V6

I have noticed on colder mornings and when the car has been sitting for a couple hours, that it is taking a couple seconds for the car to start up. Its similar to when the battery is weak but in...
Showing results 1 to 6 of 6


 
Forum Jump


All times are GMT -8. The time now is 08:18 AM.