Search: Posts Made By: carracr625
Showing results 1 to 25 of 265
Search took 1.10 seconds.
04-18-2019, 02:57 PM
Replies: 1
Views: 4,285
Posted By carracr625

fuel pump cutting out

I have 91 civic std swapped with a b18a1 OBD0 that I use on occasional weekends mainly for autocross events. While driving it the fuel pump just cuts out and the car stalls. I have found that when...
05-12-2015, 10:46 AM
Replies: 8
Views: 1,700
Posted By carracr625

Re: 91 std hatch looong term project

Yeah I wasn't happy about the header fitment, but it is minimal & I think I can clearance the oil pan slightly to remedy the issue. As far as the radiator fitment. It is caused by the full race...
05-10-2015, 02:34 PM
Replies: 8
Views: 1,700
Posted By carracr625

Re: 91 std hatch looong term project

Another issue I noticed today is that my header (Skunk2 alpha) is touching the oil pan slightly. Will this be an issue? Could it cause higher oil temps?
05-10-2015, 01:44 PM
Replies: 8
Views: 1,700
Posted By carracr625

Re: 91 std hatch looong term project

Thanks for the reply. I figured it out today. I pulled the starter out & bench tested it. It worked fine, so I put it back in & checked my wiring. As it turns out. My main chassis ground wasn't...
05-09-2015, 08:35 PM
Replies: 8
Views: 1,700
Posted By carracr625

Re: 91 std hatch looong term project

Now on to the point of this post. I've run into a few snags along the way. Right now the engine & trans are refreshed & bolted in the car. I bought a dpfi to mpfi harness from monotech on ebay. Did...
05-09-2015, 08:05 PM
Replies: 8
Views: 1,700
Posted By carracr625

91 std hatch looong term project

So I've had this hatch since 2002. I paid $600 & used it as a daily for a while with the stock 70hp 4spd & got close to 40 mpg. I blew the head gasket on the stock motor with 180k on the odo. Ever...
09-11-2012, 05:53 PM
Replies: 4
Views: 1,240
Posted By carracr625

Re: Tas auto?

I've ordered from both tas auto & rock auto with alot of success with both. They are reputable companies. I've also ordered very high quality axles from raxles.com. Very good products & alot of eye...
09-10-2012, 04:58 PM
Replies: 33
Views: 9,620
Posted By carracr625

Re: Entire FULL RACE Catalog - BEST PRICING GUARANTEED!!!

Can I get a price for EF traction bar shipped to 21234?
08-27-2012, 05:56 PM
Replies: 6
Views: 690
Posted By carracr625

Re: PRICE CHECK

Sounds like a reasonable offer to me.
08-27-2012, 02:54 PM
Replies: 6
Views: 690
Posted By carracr625

Re: PRICE CHECK

Rims or rims & tires? I'd say $200 would be a fair price for a set of clean factory 15x5.5 Honda wheels. Obviously tires would add to the price depending on the tread left.
08-27-2012, 02:52 PM
Replies: 18
Views: 7,851
Posted By carracr625

Re: RockAuto.com...?

Love those guys... cheap prices... fast shipping... & awesome customer service. You should see my order history. I always get the 5% discount too. Only suggestion I can make is to make sure you...
Forum: Tech / Misc
07-11-2012, 05:39 PM
Replies: 4
Views: 988
Posted By carracr625

Re: A/C still not blowing cold...

Anyone else? Is there anything that can be determined by the increase in pressure on the high side?
Forum: Tech / Misc
07-11-2012, 02:35 PM
Replies: 4
Views: 988
Posted By carracr625

Re: A/C still not blowing cold...

I agree that the helms says to replace the drier, but I was going with the advice of a licensed hvac tech. I figured that was gonna have to be my next step, but do you think a bad drier would cause...
Forum: Tech / Misc
07-11-2012, 01:21 PM
Replies: 4
Views: 988
Posted By carracr625

A/C still not blowing cold...

My 97 accord ex coupe was not blowing cold air any more. I believed that the compressor was on it's last leg due to the fact that there was a slight noise when it came on. I ordered a new Denso...
03-10-2012, 05:04 AM
Replies: 0
Views: 1,299
Posted By carracr625

Rear crossmember torque specs

I am re-installing the rear crossmember (the one the rear motor mount sits) & i need the torque specs for the 4 bolts holding the crossmember to the chasis. I have searched my helms manual, but just...
01-19-2012, 07:05 PM
Replies: 9
Views: 4,747
Posted By carracr625

Re: Inner tie rod question

This would be a good idea if I hadn't already installed the old design one, boot & all, thinking that I just had the wrong part. Also, I ordered them from rockauto so after paying return shipping. It...
01-19-2012, 01:16 PM
Replies: 9
Views: 4,747
Posted By carracr625

Re: Inner tie rod question

I also agree with the fact that moog makes quality parts. That's why I ordered them in the first place. However, I received 2 different designs from moog. One looks exactly like the replacement in...
01-18-2012, 05:29 PM
Replies: 9
Views: 4,747
Posted By carracr625

Inner tie rod question

I am currently rebuilding my hatch from the ground up. I am in the process of reassembling the steering rack. I had purchased Moog both inner & outter tie rod ends. My question is about the design of...
08-11-2011, 07:05 PM
Replies: 4,681
Views: 1,174,997
Posted By carracr625

Re: Road Racing / Autocross / Time Attack Picture Post!!!

Speedy, I met you at the event last weekend at FedEx field. It's hard to mistake that custom vinyl! It was nice talking to you. I can't wait to finish my car & get out there.
07-13-2011, 06:16 PM
Replies: 3
Views: 831
Posted By carracr625

Re: FS: 93 accord EX 5spd Baltimore

I still have this car for sale. I am willing to consider all offers.
Forum: Mid-Atlantic
05-31-2011, 03:11 PM
Replies: 196
Views: 34,322
Posted By carracr625

Re: Official 2011 East Coast Honda Meet (June 4th & 5th)

I sent my money for parking. All I got was the paypal receipt. Did anyone else get any other kind of response?
04-28-2011, 01:56 PM
04-26-2011, 09:02 AM
Showing results 1 to 25 of 265
 


 
Forum Jump


All times are GMT -8. The time now is 02:24 AM.