Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 14
1
2
3
11
Last »
Search: Posts Made By: Muckman
Showing results 1 to 25 of 337
Search took 1.17 seconds.
Forum: Engine Management and Tuning
10-06-2016, 07:08 PM
Replies: 6
Views: 4,283
Posted By Muckman

Re: Table Ignition vs Actual Ignition Question (Neptune RTP)

This is exactly why comparing ignition numbers are dangerous/tricky/useless because you don't know if the numbers are table ignition or actual ignition. Some people tune with the dwell tables zeroed...
Forum: Engine Management and Tuning
09-17-2016, 05:18 PM
Replies: 10
Views: 1,021
Posted By Muckman

Re: Does engine knock disable VTEC?

The oil pick up is not that close to the bottom of the pan where the thickness of the gasket will cause interference. It was probably dented in. I would be worried about your engine bearings now. Get...
Forum: Engine Management and Tuning
09-09-2016, 06:09 AM
Replies: 10
Views: 1,021
Posted By Muckman

re: Does engine knock disable VTEC?

Check your oil pressure. VTEC requires a minimum amount of oil pressure to engage.
Also check your VTEC filter screen behind the solenoid for debris that can block flow.
Forum: Engine Management and Tuning
08-05-2016, 05:41 PM
Replies: 6
Views: 679
Posted By Muckman

Re: Canīt log more than 5k

Could be interference. Are you using resistor spark plugs?
Forum: Engine Management and Tuning
07-19-2016, 05:11 PM
Replies: 12
Views: 2,593
Posted By Muckman

Re: DIY Tune vs Dyno Tune

I blew up my first 2 engines learning how to tune. Its not easy.
Forum: Engine Management and Tuning
07-07-2016, 04:09 AM
Replies: 6
Views: 2,479
Posted By Muckman

Re: Jdm b18c idle problem help plz

Did you adjust the idle air bypass set screw?
Adjusting your idle speed (Gen3) - Team Integra Forums - Team Integra...
Forum: Tech / Misc
07-07-2016, 04:06 AM
Replies: 9
Views: 3,208
Posted By Muckman

Re: Battery voltage while running

No. It sounds like your alternator is dying. Get it tested.
Forum: Engine Management and Tuning
06-12-2016, 09:17 AM
Replies: 4
Views: 973
Posted By Muckman

Re: built b18c turbo issue

You likely bought an aftermarket distributor which are notorious for being losey at everything including weak coil and inaccurate cam/crank signals. This can affect your base timing so its extremely...
Forum: Engine Management and Tuning
05-11-2016, 03:24 AM
Replies: 14
Views: 2,759
Posted By Muckman

Re: Need help with getting a hold of John Cui or anyone from CROME!

Dont let this turn into a 'how to steal Crome' thread please.
Forum: Engine Management and Tuning
05-04-2016, 03:31 AM
Replies: 21
Views: 29,124
Posted By Muckman

Re: P28-G01 C18 Blow..check engine light

I wish I could give GhostAccord an award. *Slow Clap* sir.
Forum: Engine Management and Tuning
04-24-2016, 05:59 PM
Replies: 145
Views: 86,830
Posted By Muckman

Re: OBD1 ECU COIL ON PLUG MODULE - TROJANTUNING

Can you elaborate at all about this?
Forum: Engine Management and Tuning
04-22-2016, 05:01 PM
Replies: 1
Views: 811
Posted By Muckman

Re: Low idle problem help!!

Have you set the idle set screw?
How To Adjust Honda Civic Idle Speed - My Pro Street (http://my.prostreetonline.com/2015/03/02/how-to-adjust-honda-civic-idle-speed/)
Forum: Engine Management and Tuning
04-21-2016, 04:27 AM
Replies: 9
Views: 3,974
Posted By Muckman

Re: Crome Pro Reg String

This thread has run its course. Please don't help others pirate software.
Forum: Engine Management and Tuning
04-14-2016, 05:13 PM
Replies: 3
Views: 840
Posted By Muckman

Re: Accord 2001 LX want to bypass all engine sensors can it be done

You can't bypass ALL sensors. Some sensors are crucial to engine operation such as cylinder position. What do you think fuel injection and ignition timing are based off?
Forum: Forced Induction
03-27-2016, 07:46 PM
Replies: 2
Views: 457
Posted By Muckman

Re: Can I do this for wiring my gauges? Picture

I use the same sources to power, ground and light all 5 of my gauges. You'll be fine with your plan.
Forum: Engine Management and Tuning
03-07-2016, 05:13 PM
Replies: 7
Views: 1,318
Posted By Muckman

Re: quick knocksense question

I agree with motoxxxman.
Forum: Engine Management and Tuning
02-04-2016, 11:10 AM
Replies: 8
Views: 2,241
Posted By Muckman

Re: Integra GSR Long crank

This is 100% tuning issue. cranking fuel and/or cold start enrichment fuel trim needs to be fine tuned.
Forum: Forced Induction
02-04-2016, 08:13 AM
Replies: 24
Views: 14,220
Posted By Muckman

Re: High compression b20v turbo

Its more of a testament of how far you can push stock blocks; that's all. We all know its a time bomb. Some last longer than others.
Forum: Forced Induction
02-04-2016, 04:14 AM
Replies: 24
Views: 14,220
Posted By Muckman

Re: High compression b20v turbo

We don't seek out builds to add to the list. The owners need to contact me and I will add it to the list.
Another point I wanted to make is the Highest HP list shows B20 owners have not been...
Forum: Engine Management and Tuning
02-03-2016, 07:36 PM
Replies: 23
Views: 16,268
Posted By Muckman

Re: S300 V3 vs Demon V2

The Neptune + Demon combo is about $100 cheaper than a S300v3. The basic core features are identical. The extra features of the S300 may not have any value to you but thats something you need to...
Forum: Engine Management and Tuning
01-19-2016, 04:56 PM
Replies: 5
Views: 2,219
Posted By Muckman

Re: Shared cells in fuel map between WOT and part throttle

The part throttle aspect wouldn't matter if the manifold air pressure is the same. Does the FIC have gear based fuel trim that you can use to compensate?
Forum: Engine Management and Tuning
12-30-2015, 03:29 AM
Replies: 11
Views: 2,701
Posted By Muckman

Re: Cylinders flooded with fuel

swap problem injector to a new cylinder. see if problem follows injector.
Forum: Engine Management and Tuning
12-03-2015, 05:39 AM
Replies: 9
Views: 5,180
Posted By Muckman

Re: Why do fuel values drop on fuel tables?

You'll find a well tuned fuel map (at WOT) will represent the torque curve (VE).
Forum: Engine Management and Tuning
11-27-2015, 07:10 PM
Replies: 5
Views: 838
Posted By Muckman

Re: 98 b20b turbo tuneing help

No. Some tuners offer tuning over the internet where they send you calibrations. You street test them, datalog and send them the results, update, repeat.

Best is to have it towed to the closest...
Forum: Engine Machining & Assembly
11-20-2015, 06:52 PM
Replies: 12
Views: 1,427
Posted By Muckman

Re: honda bearing question

I said "most" not all.
Showing results 1 to 25 of 337
 
Page 1 of 14
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 08:58 PM.