Voltex GT wing type 1/3. Anyone running them?
#1
Honda-Tech Member
Thread Starter
Voltex GT wing type 1/3. Anyone running them?
Planning on getting a Voltex wing for my new integra(time attack), I have a few questions before I order mine. My teg an RS so no wing ever came with it which eliminates the need for the "special mounts" right?? as I'm just drilling fresh. 2nd there are two types the "type 1" and then the "type 3", the type 1 has the integra listed as an application however the type 3 doesn't but could that just be that it doesn't have the special mounts for it?. It comes in the same 1,500-1,700mm size, and the post look to be in the same place again I'm starting with a hole-less truck so I don't have to worry about the old ones interfering. specs for mine would be 1,500mm + 245mm posts with 30mm post risers(just in-case). I'd like to hear anyone's experience with it in general thanks, pics posted below.
Type 1
Type 3
Type 1
Type 3
#2
Honda-Tech Member
iTrader: (3)
Re: Voltex GT wing type 1/3. Anyone running them?
with the RS trunk lid you dont need the special mounts. even if you did have a factory winged integra, you'd just have extra holes in the trunk (because showcar!) if you didnt use the special mount....
you are definately going to want a front splitter set up if you are adding a wing.
you are definately going to want a front splitter set up if you are adding a wing.
#3
Honda-Tech Member
Thread Starter
Re: Voltex GT wing type 1/3. Anyone running them?
Those are already made, this is a big ticket item so I was putting it off. have a rear diffuser being on order too.
Thread
Thread Starter
Forum
Replies
Last Post