B16A Hydro Transmission Fully Rebuilt
07-08-2015, 03:14 PM
#1
B16A Hydro Transmission Fully Rebuilt
I have a real B16A Hydro transmission that just had a Syncro Tech full rebuld kit installed.
I was going to do an H2B but I am selling everying. I also have a set of B series billet mounts for DC/EG.
Asking $750 OBO
The pictures of the measurements show the measurement of the ring gear. I did not want to take the diff apart because the bolts are not meant to be re-used.
The 129.31 is the bolt center to center, then you minus the diameter of the bolt to calculate the inside diameter of the ring gear. B16 is ~110 and GSR is ~116.
I was going to do an H2B but I am selling everying. I also have a set of B series billet mounts for DC/EG.
Asking $750 OBO
The pictures of the measurements show the measurement of the ring gear. I did not want to take the diff apart because the bolts are not meant to be re-used.
The 129.31 is the bolt center to center, then you minus the diameter of the bolt to calculate the inside diameter of the ring gear. B16 is ~110 and GSR is ~116.
Thread
Thread Starter
Forum
Replies
Last Post