Need help on SH
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2005
Location: Bham, al united states
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
Need help on SH
Putting new bushings on my SH and got ahead of myself of the radius rod. On both left and right rod I pressed the bushings and metal Sleeve out of the radius rod. I wasn't suppose to press the metal sleeves out. Problem is the sleeve goes in the rod fine but I don't know what sleeve goes in left or right rod. The metal sleeve when in the rod has one side that sticks out more then the other. I don't know what side has more width of the sleeve sticking out (going up to the engine bay or down to the ground). I will take a pic in the morning dont have anything to at shop but if someone can check there SH they be able to see what I'm talking about
#2
Honda-Tech Member
Thread Starter
Join Date: Sep 2005
Location: Bham, al united states
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need help on SH
I believe I have figured it found a used radius rod on the Internet and looking at the pic I think I can tell what I needed to know. Been working all day all new bushings. Ball joints wheel bearings inner tie rods. Outer tie rod, end links front and back. New tires. All I can say is redoing your bushings is not easy but we have a lot of tools to work with. Will post pics in a day or two
Thread
Thread Starter
Forum
Replies
Last Post
Blaze45
Honda CRX / EF Civic (1988 - 1991)
3
05-15-2004 10:54 AM