Zc axles and int shaft on Si trans?
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2004
Location: Albuquerque, NM, usa
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Zc axles and int shaft on Si trans?
I recently bought a set of zc axles and int shaft because i was supposed to be getting a zc trans, but that deal fell through. Now I can get a good deal on an Si trans. I have a sohc zc vtec motor that has the holes for the int. shaft. So my question is can i use the zc int shaft and axles with an Si trans?
Thanks
Thanks
#2
Honda-Tech Member
Re: Zc axles and int shaft on Si trans? (d16vtecx)
short answer, yes if you had the DOHC diff ONLY, or the bigger side gears from a integra i think.
long answer, read this thread to understand why. (yes its the reverse of what youre asking, but its the same principle.)
https://honda-tech.com/zerothread?id=1793626
long answer, read this thread to understand why. (yes its the reverse of what youre asking, but its the same principle.)
https://honda-tech.com/zerothread?id=1793626
#3
Honda-Tech Member
Join Date: Sep 2002
Location: colorado springs, co, usa
Posts: 5,643
Likes: 0
Received 28 Likes
on
28 Posts
Re: Zc axles and int shaft on Si trans? (d16vtecx)
you will need a ZC differential carrier and side gears - the intermediate shaft will not fit in a DX/Si differential carrier - the hole that the axle goes through is too small
#4
Honda-Tech Member
Thread Starter
Join Date: Sep 2004
Location: Albuquerque, NM, usa
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Re: Zc axles and int shaft on Si trans? (jlicrx)
there aren't any integra diffs or side gears i could use? because i dont have much access to zc parts
and how would i go about changing the diff and side gears? I have never opened a trans so it is all new to me
thanks for the info
and how would i go about changing the diff and side gears? I have never opened a trans so it is all new to me
thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post
tico
Honda CRX / EF Civic (1988 - 1991)
45
09-05-2008 09:23 AM