Re: what's the torque specs for main bearing caps?? (ef8sleepr)
Different sizes of main bearings may be present in the same engine. To find the correct bearing size for each journal, use the provided chart to properly reference the code markings on block and crankshaft
Re: what's the torque specs for main bearing caps?? (Janos Lin)
Originally Posted by Janos Lin
Let me put it this way, the "sets" are usually like ACL, or whatever, those are middle of the road sizes, or green according to the factory chart.
You can only get individual bearings from Honda themselves and they cost quite a bit more once you get all 10 halves, but you can be assured of having consistent and known oil clearences.
ic... but if i just want a set from the parts store which size should i get?? i plastigauge the clearance and my results were .003 in. and the specs on the repair manual says .0010-.0014 on 1&5 journals, 2&4 .0010-.0017, and 3 is .0012-.0019... that's way big right?? so i need undersize bearings??? help me out! and the plastigauge came with 2 colors, i used the red... is that the one i should use???
I hate thieves!!!
15 sec. car in the works...
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.