uberdata datalogging cable soldering and installation
#1
Honda-Tech Member
Thread Starter
Join Date: Aug 2004
Location: las cruces, new mexico, usa
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
uberdata datalogging cable soldering and installation
hello i have a p28 ecu, ready for uberdata, the only thing i am lacking is how to solder in the data logging nokia usb cable. i have lots of wires on my cable i know i need to use the red, orange and ground. what are the red and orange tx,rx. please let me know. i have searched profoundly and found minimal actual installation instructions, maybe i am blind but please help, or show me to a page that can help. thanks
#2
Honda-Tech Member
Join Date: Sep 2002
Location: hittin corners so hard you can taste my rims..
Posts: 5,415
Likes: 0
Received 0 Likes
on
0 Posts
Re: uberdata datalogging cable soldering and installation (pinche)
#3
Join Date: Jul 2003
Location: CLOSER THAN YOU THINK
Posts: 1,234
Likes: 0
Received 0 Likes
on
0 Posts
Re: uberdata datalogging cable soldering and installation (Built B16A)
go to this site http://www.ecimulti.org/uberdata/ for the soldering inside the ecu where it says cn2 u have to use the radioshack cable part number 170787 its 10 dollars cut off the end tap into wire brown, red and orange the rest u don't need cut them and tap them off.
On the ecu u solder wires from or run wires off and solder them to pin 1,2,4 u don't use 3 or 5
pin 1 is brown
pin 2 is red
pin 4 is orange double check keebler site for what 2 connect but these are the right pins 1,2, & 4
On the ecu u solder wires from or run wires off and solder them to pin 1,2,4 u don't use 3 or 5
pin 1 is brown
pin 2 is red
pin 4 is orange double check keebler site for what 2 connect but these are the right pins 1,2, & 4
Thread
Thread Starter
Forum
Replies
Last Post
djnikko
Engine Management and Tuning
4
12-21-2009 03:33 AM
JDMlyfestyle
Honda Civic / Del Sol (1992 - 2000)
37
10-16-2005 08:42 AM