erikiksaz1

http://www.jcwhitney.com/webap...90435

1st question - Are these keyed difference?
2nd question - Since they're closed end, will 12mm x 1.50" fit? My old lug nuts were open ended, i've never used close-ended ones before.



OR



Should i just get 2 different sets of gorilla lock nuts and the other 2 i'll use standard tapered nuts? That would be much cheaper, under 20, and i'd have 2 different sets of lock nuts.




Modified by erikiksaz1 at 2:00 AM 3/18/2004

GreenMachineRex

even if u find the right size. ******* ******** @ summit sent me the wrong size. and i wasn't paying attention and threw them on. and i was like wtf. these are impossible trying to go off.

long story short i had to replace the front stud. just one thankfully. i think 1.50 is the correct size. but don't take my word for it.

CRXDrew

12mm x 1.50 is correct.

I love my gorillas. I don't think they are keyed different, but the spline drive kicks ***.

Just go ahead and buy one set of lugs. I don't see the point of buying two whole sets of locking nuts and using only half of them.

erikiksaz1

Noo, what i mean is that i'll buy 2 sets of 4 locking lug nuts. All the local stores around here either sell 1 set of 4 for 15 bucks or 1 set of 16 for 60 dollars.

silverCRXTC

I lost a gorrila lug and the sticker with the key # only has an adress to get another key, does anyone know how to get just one lug? (or is there only one basic crx type lug?)