Is this thermostat casing okay to use?
03-23-2015, 05:54 PM
#3
Steve at Heart
Re: Is this thermostat casing okay to use?
Just clean it up and install already. Why would the nipple make a big difference? The bolts and one nipple should align everything fine.
03-24-2015, 08:24 PM
#5
Re: Is this thermostat casing okay to use?
so, it has about 1-2 mm play with the tab and the nipples.
They're only there for alignment purposes
I replaced the o ring on both ends for safe measure. and the end that goes into the water pump also has a tab but no alignment nipples.
Good tip for anyone doing this. wet the o rings with antifreeze so they go in easier
They're only there for alignment purposes
I replaced the o ring on both ends for safe measure. and the end that goes into the water pump also has a tab but no alignment nipples.
Good tip for anyone doing this. wet the o rings with antifreeze so they go in easier
Thread
Thread Starter
Forum
Replies
Last Post
bandit67
Honda Civic / Del Sol (1992 - 2000)
4
12-13-2014 08:26 AM