obd1 b16 swap in 90 crx si
04-14-2013, 04:52 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: you probably haven't heard of it, TEXAS
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
obd1 b16 swap in 90 crx si
I dont have any CELs and no vtec. I swapped the vtec solenoid and pressure switch plugs and got CELs for the so I swapped them back and CELs are gone. I have triple checked the harness. I had the vss code untill I swapped out the electrical vss with the mechanical vss. Now my speedo works and the vss code is gone, but no vtec. Do I have to wire the vss or does the jumper harness take care of it? I have searched and haven't found a definite fix. Any help is appreciated.
04-16-2013, 12:40 PM
#3
Keyboard Humorist
Join Date: May 2002
Location: Granada Hills, Ca, USA
Posts: 9,814
Likes: 0
Received 9 Likes
on
7 Posts
Re: obd1 b16 swap in 90 crx si
operating temp, vehicle at speed (vss must be working) and correct oil pressure
A very typical reason or vtec no working is being a little low on oil.
A very typical reason or vtec no working is being a little low on oil.
04-20-2013, 05:14 PM
#4
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: you probably haven't heard of it, TEXAS
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Re: obd1 b16 swap in 90 crx si
Oil is good. Just need to know if extra wiring is needing for vss. Obd0 guages to obd1 ecu.
Thread
Thread Starter
Forum
Replies
Last Post
skateroyals
Honda CRX / EF Civic (1988 - 1991)
7
12-15-2008 08:24 PM
LSracing94
All Motor / Naturally Aspirated
17
08-07-2006 10:00 AM
white91rex
Honda CRX / EF Civic (1988 - 1991)
2
04-24-2005 04:23 PM