jew4u2nv

ive been searching for this problem in the archive for about 2 days, but if anyone can find this this problem there, i apologize

the problem is, i just purchased a new Walbro 190lt/hr fuel pump, ive done the steps of dropping my tank and removing the fuel pump, but i cant figure out how to wire this new but. the problem is the new pump has a 2 wire setup on the harness it gave me, my crx HF pump runs off of a single wire (which is obviously power) ive heard some pumps are self grounding.

so im wondering what to do with my 2 wire fuel pump to make it compatible with the single wire HF pump wiring??

thanks, and again i apologize if this is in the archive somewhere

DXDOHCVTEC

My guess would be to use the wire that is already there as the hot and run your own ground wire, that should work fine.