Gsr hydro trans internals into ys1 cable trans question
#1
Honda-Tech Member
Thread Starter
Gsr hydro trans internals into ys1 cable trans question
So i've swapped 2001 gsr hydro internals into my ys1 cable trans years ago, and i remember reading about shimming the differential or something, but I remember not knowing how to do it so i skipped that part. Everything ran fine though, but i'm about to pull out my tranny to replace the input shaft bearing aka clutch housing bearing, so i figure i should probably shim it or at least check the clearance. Problem is, i can't find the forum i used as a guide.
Does anyone know how to do this or even have the specs?
Does anyone know how to do this or even have the specs?
Thread
Thread Starter
Forum
Replies
Last Post