DOHC ZC wiring into 90' Si
05-22-2005, 03:30 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2004
Location: Somewhere, BC, Canada
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
DOHC ZC wiring into 90' Si
So I have my DOHC ZC ready to go in, only problem is that one harness plug(square white one with a 6 pin conector on the drivers side) doesnt match up with the Si's plug. The D16A6s plug has a round 8 pin harness, and the ZC has a square 6 pin harness. Am I suposed to swap the Si Harness over to the ZC engine? Or is there a mod im able to do that will make the ZCs harnes work with all the Sis conections? Also, is what am I suposed to do about the cam angle sensor? What do I have to do to make everything work right? Thanks.
05-22-2005, 04:26 PM
#2
Honda-Tech Member
Join Date: Nov 2002
Location: San Jose/ Monterey, ca, usa
Posts: 5,846
Likes: 0
Received 1 Like
on
1 Post
Re: DOHC ZC wiring into 90' Si (SC-MK1)
extend the cps wires to the external position on the exhaust cam, my site has a jumper if you really need one. http://www.rywire.com
05-22-2005, 08:51 PM
#5
Join Date: Dec 2003
Location: Griffin, GA
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
Yes, swap over the Si engine harness Everything will plug up except for 1 2 wire plug near the intake and the Dizzy plugs, Change the connector to the square one from a 88-89 Teg, and extend 2 wires from the dizzy wires to hook up the CPS and your done.
Its simple. But Hasport sells the conversion kit from Si-ZC for like $40 if your not into wiring anything.
Its simple. But Hasport sells the conversion kit from Si-ZC for like $40 if your not into wiring anything.
Thread
Thread Starter
Forum
Replies
Last Post
Redemption
Honda CRX / EF Civic (1988 - 1991)
3
09-25-2009 09:48 AM
The Destroyer
Honda CRX / EF Civic (1988 - 1991)
11
12-30-2005 02:22 PM
gregv
Honda CRX / EF Civic (1988 - 1991)
3
09-11-2002 03:24 AM
vtec_head
Honda CRX / EF Civic (1988 - 1991)
3
05-08-2002 08:59 AM
