replaced head gasket now car won't start
#1
Thread Starter
Join Date: Feb 2008
Location: Spartanburg, sc, USA
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
replaced head gasket now car won't start
i replaced the head gasket in my b16 and just finished putting it back together. I did a compression test and all cyl are fine. But now the car wont start. It will turn over like it wants too. I can hear the fuel pump working so i'm pretty sure it's not fuel.
I have an OBD0 and it's giving a "Ignition Output Signal" code other than that i don't know why the car won't start. The distributer was purchase 3 months ago from distributer king so it's still new.
Anyone have any ideas??
I have an OBD0 and it's giving a "Ignition Output Signal" code other than that i don't know why the car won't start. The distributer was purchase 3 months ago from distributer king so it's still new.
Anyone have any ideas??
#3
Senior Member
Join Date: Aug 2004
Location: Rota, Cadiz, Spain
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
Re: replaced head gasket now car won't start (mizerb16)
definitely low on blinker fluid. but seriously. hold the spark plug wire about a half an inch from its place on the cap, try to start it and look for an arc between the two. if not, i'd have to say timing, check your fuses to be sure, and then once again, the blinker fluid.
Thread
Thread Starter
Forum
Replies
Last Post
deepfriedjinx
Honda Civic (2001 - 2005)
12
07-30-2014 06:39 AM
deepfriedjinx
All Motor / Naturally Aspirated
3
06-22-2011 07:07 PM
Red93AWD
Honda Civic / Del Sol (1992 - 2000)
10
08-16-2005 06:45 PM