OEM horn connector
#1
OEM horn connector
I wanted to upgrade the horn in my car for safety reasons. I was doing some research and found that I liked the PIAA Sports horn 400/500 dual tone horn.
The problem comes with installation. I really do not want to hack up my harness just to install these. The 2000 civic has just a single horn with a one pin connector on it. The directions say to just cut the end off and crimp on the wires included. I would like to make almost a connector for it that plugs directly into the harness.
What are your thoughts on this? Do you know also where I could get the horn side of the connector without ripping one apart? Or should I just go about ripping a junk horn apart and robbing the connector off of it?
The problem comes with installation. I really do not want to hack up my harness just to install these. The 2000 civic has just a single horn with a one pin connector on it. The directions say to just cut the end off and crimp on the wires included. I would like to make almost a connector for it that plugs directly into the harness.
What are your thoughts on this? Do you know also where I could get the horn side of the connector without ripping one apart? Or should I just go about ripping a junk horn apart and robbing the connector off of it?
#2
Honda-Tech Member
Re: OEM horn connector
It's not hacking if you wrap the wires and make it look clean how do you think kill switches/alarms are installed. wires will need to be cut/spliced.
Thread
Thread Starter
Forum
Replies
Last Post
justint
Audio / Security / Video
2
05-09-2006 07:34 PM
averyvm
Honda Civic / Del Sol (1992 - 2000)
3
11-03-2005 10:17 PM