here is the problem. i did a ls 98 ls swap on my 92 civic dx. i'm using a dx engine harness and the car is running fine. the one problem is that i do not see where i have to connect the o2 sensor. i only see a couple of extra plugs and i dont believe they are the ones. any one have a description or the wire colors for the o2 sensor wires coming off the harness?
ok i see a white, yellow/ black, orange black, and a green white wires not plugged into any thing and its near the front of the motor . and the o2 sensor is down under on the headers, the wires on the 02 sensor are green, whire and there are 2 black wires. can any one match them up for me?
ok i got it hooked up. at first i was going to cut the wires and make them longer but then i just figured to open up the harness and pull the harness for the o2 sensor out until it is long enough . its good now but it is still showing the code for the o2 sensor and i think i need the tps also because of teh rough idle. another issue, this never ends.
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.