HELP HELP ME PLEASE!!!!!!!!!!
#1
Thread Starter
Join Date: Dec 2003
Location: nj, usa
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
HELP HELP ME PLEASE!!!!!!!!!!
i just finished one of my freinds swaps. everything went fine. I also put in a exedy clutch. So i start the car and take it for a test drive. I put it in first gear and im driving along then i shift to second, it revs up to like 5000 and then the car just looses power and the car is still reving... im thinking wtf did this new clutch slip...
i put it back into first and nothing.... i can rev it to 8000 and the car still wont go...
so i push it back to my house.. i try everygear and the car wont move just rev.... WTF IS WRONG!!!!! is the clutch not aligned right or something???? its a 94 gsr hydro tranny on a b16a1 motor
#2
Honda-Tech Member
Re: HELP HELP ME PLEASE!!!!!!!!!! (mustbenu)
Re install the clutch, and do a proper break in. You may have already toasted it since you are not supposed to go over 3000 rpm for the first 500 miles of street driving!
#3
Mr. Badwrench
Join Date: May 2002
Location: stranger in a strange land
Posts: 14,146
Likes: 0
Received 2 Likes
on
2 Posts
Re: HELP HELP ME PLEASE!!!!!!!!!! (mustbenu)
if the clutch wasnt aligned correctly, you wouldnt have been able to install the trans. make sure one of the axles hasnt popped out. that has happened before. if it isnt seated in the diff all the way it can pop out. try that. then correctly break in the clutch.
Thread
Thread Starter
Forum
Replies
Last Post
PreClude
Honda Prelude
16
11-21-2012 11:37 AM
mustbenu
Honda CRX / EF Civic (1988 - 1991)
11
06-02-2004 03:30 PM