1992 civic starting problems
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
1992 civic starting problems
So I have a 1992 honda civic si I went to leave in my car it started up fine I turned it off and now it won't start up! I've checked the battery I replaced the starter with a new one I've checked all mu grounds everything is good.. the starter wire on the ignition switch is only reading 2volts and the starter signal fuse is only getting 2.5 3volts.. I tried to jump the starter too and nothing!! I'm going crazy any input would be appreciated
#2
Re: 1992 civic starting problems
From your post I get the impression the car is not cranking the motor over?
Am I understanding your issue properly?
Am I understanding your issue properly?
#3
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
Yes!! I can hear the main relay and the starter relay that's up under the dash click. But if I push start it it'll fire right up
#7
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
I did a voltage drop on the small wire on the starter it's getting 11.95 volts without the key turning over when I turn the key over I'm getting 0.648 volts
Trending Topics
#8
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
I went to the junk yard today and replaced the ignition switch it still isn't starting but somthing I noticed is that the (st) wire on the ignition switch is getting 12.15 volts but as soon as I push the clutch in I get 2 volts? Is there a wire touching? Or could it be somthing else?
#12
#13
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
I used a multimeter to messure the voltage on the clutch saftey switch when I pushed the clutch in and tried to start it the volts were 0. But when I tested it without pushing the clutch in it was reading 12 volts
#14
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
A guy I work with told me to check the black/white wire that goes on the starter solenoid. So I checked the black/white wire on the starter solenoid when it was hooked up and cranking the motor I was only getting 2 volts then I checked it when it was unhooked and cranking the motor and I was getting 11.5 volts.. is somthing getting grounded?
#16
Honda-Tech Member
Thread Starter
Join Date: Jan 2013
Location: kentucky
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1992 civic starting problems
I hear a clicking I think it's coming from the starter motor. I tested the voltage from the wire that goes from the battery to the stud on the starter I get 6 to 8 volts but goes down if you hold it for a few seconds
#17
Re: 1992 civic starting problems
What did you use for ground in this^ voltage test?
Thread
Thread Starter
Forum
Replies
Last Post
cksnah252
Honda Civic / Del Sol (1992 - 2000)
12
09-09-2014 07:51 AM
Schultzie
Tech / Misc
4
01-23-2013 09:46 PM
happyabortion
Honda Civic / Del Sol (1992 - 2000)
6
12-10-2012 05:11 PM
mtber
Acura Integra Type-R
9
07-14-2004 09:02 AM