Removing Fender on 95
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2008
Location: Orange County, CA,
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
Removing Fender on 95
How many bolts are there to remove the fender?
I know there are few in the engine bay area. Are there any bolts inside the wheel well?
Thanks!
I know there are few in the engine bay area. Are there any bolts inside the wheel well?
Thanks!
#3
Honda-Tech Member
Re: Removing Fender on 95
There are a bunch of plastic screws holding the plastic mud guard to the fender rim in the wheel well. There are two bolts behind the corner of the bumper, below the turn signals. You will need to remove the bumper bolt to get at them. There is also a bracket that connects the fender to the frame rail with two bolts.
There are also two bolts where the fender meets the door. If you open the door you will see them. one is up near the top door hinge and the second is down at the very bottom of the fender where it meats the rocker panel.
There are also two bolts where the fender meets the door. If you open the door you will see them. one is up near the top door hinge and the second is down at the very bottom of the fender where it meats the rocker panel.
#4
Honda-Tech Member
Re: Removing Fender on 95
There are 3 or 4# 13 that hold the plastic to the fender. The far left #8 is inside the engine bay below the power steering reservoir. It is easier to remove that bracket bolt than the one attached to the fender. The bracket tends to twist when you try to loosen the bolt on the fender side.
Thread
Thread Starter
Forum
Replies
Last Post