1993 accord lx brake pedal travels to floor after brake job
#1
Honda-Tech Member
Thread Starter
1993 accord lx brake pedal travels to floor after brake job
I replaced the front rotors, pads, driver's side axle, and replaced the brake fluid by bleeding at all 4 points.
Now to my surprise, the pedal travels to the floor (!). After doing some reading online, I decided to replace the master cylinder.
Now, after a new master cylinder, the pedal STILL travels to the floor. What is going on here?!
(firm then spongy with car off, travels to the floor with car running).
Please help!!
Now to my surprise, the pedal travels to the floor (!). After doing some reading online, I decided to replace the master cylinder.
Now, after a new master cylinder, the pedal STILL travels to the floor. What is going on here?!
(firm then spongy with car off, travels to the floor with car running).
Please help!!
#2
Honda-Tech Member
Join Date: Mar 2011
Location: Rock Hill, SC
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Re: 1993 accord lx brake pedal travels to floor after brake job
you have a bubble somewhere still. i had the same problem before i also changed the master cylinder still had bad pedal.. i found my air bubble in the rear.. i had to bleed like a half a quart to finally get it out.
#3
Honda-Tech Member
Thread Starter
Re: 1993 accord lx brake pedal travels to floor after brake job
You were right campfire - to eliminate the possibility, I went around again and bled all the brakes - all is fine now.
Thread
Thread Starter
Forum
Replies
Last Post
sobey
Honda Accord (1990 - 2002)
10
03-11-2009 06:08 PM
JZA70
Honda Accord (1990 - 2002)
4
11-14-2006 11:16 AM