(MS)WTS: My built for boost D16z6
#1
Honda-Tech Member
Thread Starter
iTrader: (2)
Join Date: Dec 2009
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
(MS)WTS: My built for boost D16z6
Taylor T.
Location Gulfport MS
contact 228-313-4022 or pm
Hey everyone i no longer have a car to put this beast in so im putting it up for sale. For the long block only i want $1200. This includes the built block, head, intake mani. Fully timed and ready to slap into a vehicular(with addition of flywheel/clutch.)
For $1500 i will throw in a 5 speed trans w/shift fork(no t.o.b), d16z6 wiring harness(no cut plugs), d16z6 distributor, and d16 flywheel(resurfaced and ready to go with pilot bearing). The machine work was done by Big2 Engine Builders of Gulfport MS. I have numerous receipts for everything. If you have any further questions just shoot me a text or call.
The block has:
YCP Vitara Pistons
Eagle Rods w/ ARP rod bolts
New OEM Oil/Water pump
Oem Honda Main/Thrust bearings
ACL Rod bearings
ARP Head Studs
OEM Rear main seal
OEM Main cap bolts
Block has been cleaned/machined/decked properly
OEM Headgasket
Head was pressure tested and cleaned
Im sure there is something ive missed.
Location Gulfport MS
contact 228-313-4022 or pm
Hey everyone i no longer have a car to put this beast in so im putting it up for sale. For the long block only i want $1200. This includes the built block, head, intake mani. Fully timed and ready to slap into a vehicular(with addition of flywheel/clutch.)
For $1500 i will throw in a 5 speed trans w/shift fork(no t.o.b), d16z6 wiring harness(no cut plugs), d16z6 distributor, and d16 flywheel(resurfaced and ready to go with pilot bearing). The machine work was done by Big2 Engine Builders of Gulfport MS. I have numerous receipts for everything. If you have any further questions just shoot me a text or call.
The block has:
YCP Vitara Pistons
Eagle Rods w/ ARP rod bolts
New OEM Oil/Water pump
Oem Honda Main/Thrust bearings
ACL Rod bearings
ARP Head Studs
OEM Rear main seal
OEM Main cap bolts
Block has been cleaned/machined/decked properly
OEM Headgasket
Head was pressure tested and cleaned
Im sure there is something ive missed.
Thread
Thread Starter
Forum
Replies
Last Post
splatterpaintdc
Mid-West (Sales)
1
09-15-2010 04:33 PM
DelSolDon
Classifieds: Forced Induction
43
05-22-2007 10:54 AM