Tkymik

Has anyone tried the Zerg 2 ply head gasket? Does anybody know its thickness? Thank you.

accorse07

0.47

seelback

im using on my b20vtec setup. i copper sprayed it and it sealed fine, i bent all the valves in the head the same week i put the head on, pulled head, put new valves in, cleaned the already used zerg head gasket, copper sprayed it again and it sealed fine again. and its been going for about 1.5-2 years with no problems. im also using arp head studs

EsotericImage

iTrader: (8)

Damn thtas tall!

accorse07

That is in "mm" since we are on the subject of Thin head Gaskets...they all mostly come from Japan and such so I am used to stating them in that measurement.
It is .0185 in comparison to a stock Honda gasket which is .027?

Tkymik

Thanks.. so that would retard the cams by 1.5 degrees?

EsotericImage

iTrader: (8)

I use an OEM 3 layer and my crush thickness is .023 with feeler gauge