spoon93

Ok so I'm building a b20 v I'm using a skunk 2 pro series im with a hondata gasket my question is... Is it a good idea to use a thermal tb gasket as well for a skunk 70 m tb or is that too much spacing out to use both thermal gaskets and if Its fine where can I get one thanks

.Manny.

iTrader: (1)

I've always used both OEM and Thermal gaskets without a problem. Just make sure the mating surfaces are nice and clean. Also, make sure the opening of the TB, gasket, and manifold all match up.

B20vEf9

I've always used the Hondata Intake Manifold gasket, and the gasket that came with the throttle body.

TheShodan

iTrader: (14)

I use the Outlaw Engineering TB and IM composite gaskets. Honda and Mazda's little secret to low temps in road race applications. We notice significantly lower IATs than with the Hondata one or P2R, or any of the others. It costs a little more at $117 bucks shipped, but it is a truly complete kit




Here it is as the kit..




Here it is in the Car of Project "SHE"

Intake manifold gasket..



Throttle Body Gasket...The TB gasket can be ported to fit over 68mm.
This one has a Skunk2 Alpha 70mm TB on a ported ITR manifold



Here's their information: feel free to e-mail and get more info
http://www.outlawengineering.com/HondaB16AFrame.html