Cmanning816

Jdm H22A m2s4 trans tuned at 208 completely stock swap my plug wires pop off of the damn spark plugs any suggestions never ran into a problem like this.

OMG

what kind of wires

ef2_civic

iTrader: (1)

Agreed and how did it occur?

Cmanning816

Ngk blues

OMG

check the spark plug well seals in the valve cover. Blow-by pressure might be popping them off

DDTECH

Like rocket said check those.. also take some needle nose and squeeze the tip together a bit should help with holding on as well.

Cmanning816

If the well seals were leaking would there be oil ?
And I have made sure all plug wires are vented properly an even made a couple extra holes just in case and they are NHL blues the pice around the metal contact that slides over the end of the spark plug is covered with hard plastic and it is way too deep to reach with needle nose help I can't figure this one out

OMG

pull a plug boot out of the motor

take a spark plug and stick it into the plug boot and see if it clicks tightly