swap help please
#1
swap help please
Ran into a few problems if anyone can lend a hand.
1. On the driver side the bolt on the hub which attaches to the low control arm is spinning.. i cannot get my crown nut onto it, what to do I do?
2. The axles will only go in one way as far as driver/passenger I believe right? Because I am having a difficult time getting the passenger axle into the half shaft, did I maybe stick the pass axle into driver side lol
if anyone could shed some light it would be great
1. On the driver side the bolt on the hub which attaches to the low control arm is spinning.. i cannot get my crown nut onto it, what to do I do?
2. The axles will only go in one way as far as driver/passenger I believe right? Because I am having a difficult time getting the passenger axle into the half shaft, did I maybe stick the pass axle into driver side lol
if anyone could shed some light it would be great
#2
Re: swap help please
1. to get that lower ball joint nut to stop spinning, put another jack under that control arm and jack it up so there is a load pressing the control arm into the ball joint. Should be good then, dont be cheap and make sure you put a cotter pin in the castlated nut because if that comes apart while your driving down the road, your gunna have a bad day.
2. look at your axles side by side and see if they are identical. Make sure the splines are lined up, sometimes these can be a pain to get in all the way because of the c-clips on the tip of the axle
2. look at your axles side by side and see if they are identical. Make sure the splines are lined up, sometimes these can be a pain to get in all the way because of the c-clips on the tip of the axle
Thread
Thread Starter
Forum
Replies
Last Post