pressure plate torque specs
#2
Honda-Tech Member
iTrader: (1)
Join Date: Jan 2002
Location: Nowhere and Everywhere
Posts: 29,530
Likes: 0
Received 53 Likes
on
47 Posts
Re: pressure plate torque specs (sikcrx80)
80-something I think, just a little higher than the wheel lug nuts if I remember from replacing my brother's del Sol clutch just last week. Put a breaker bar or something on the crank pulley bolt to keep the engine from rotating while you tighten the bolts.
#3
Honda-Tech Member
Join Date: Jun 2004
Location: Miami, Fl, USA
Posts: 4,215
Likes: 0
Received 0 Likes
on
0 Posts
Re: pressure plate torque specs (PatrickGSR94)
I just did mine yesterday and the helms recommends 19lbf-ft. They flywheel was at 76lbf-ft.
Ill post a pic of the helm's manual in a minute.
Ali
Ill post a pic of the helm's manual in a minute.
Ali
#4
Re: pressure plate torque specs (PrinceAli132)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by PrinceAli132 »</TD></TR><TR><TD CLASS="quote">I just did mine yesterday and the helms recommends 19lbf-ft. They flywheel was at 76lbf-ft.
Ill post a pic of the helm's manual in a minute.
Ali</TD></TR></TABLE>
Ill post a pic of the helm's manual in a minute.
Ali</TD></TR></TABLE>
#5
Re: pressure plate torque specs (PatrickGSR94)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by PatrickGSR94 »</TD></TR><TR><TD CLASS="quote">80-something I think, just a little higher than the wheel lug nuts if I remember from replacing my brother's del Sol clutch just last week. Put a breaker bar or something on the crank pulley bolt to keep the engine from rotating while you tighten the bolts.</TD></TR></TABLE>
80lb.ft on pressure plate bolts? no..
19lf.ft is the correct spec
80lb.ft on pressure plate bolts? no..
19lf.ft is the correct spec
#6
Honda-Tech Member
Join Date: Jun 2004
Location: Miami, Fl, USA
Posts: 4,215
Likes: 0
Received 0 Likes
on
0 Posts
Re: pressure plate torque specs (Sleeper Style)
Sorry for the crappy fast pic, but im eating right now so i really didn't car too much. Don't forget to tighten in a criss-cross pattern.
Ali
Ali
#7
Honda-Tech Member
iTrader: (1)
Join Date: Jan 2002
Location: Nowhere and Everywhere
Posts: 29,530
Likes: 0
Received 53 Likes
on
47 Posts
Re: pressure plate torque specs (PrinceAli132)
ah doh! my bad, I was thinking flywheel... yes I remember know how much of a PITA it was to tighten the flywheel bolts to 80+ lb-ft. w/ those little shorty heads on them. Busted knuckles FTL
Thread
Thread Starter
Forum
Replies
Last Post
1QwIkEf
Drag Racing
8
09-09-2007 09:07 PM