OBD1 Injector Wiring Help
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2011
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
OBD1 Injector Wiring Help
Hey guys, I pulled the motor and tranny out of my 93 Integra RS (motor is a 94 GSR). The b18c swap was done by the previous owner and for whatever reason the injector clips were jb welded to the injectors. WHen I pulled the motor for paint and wire tuck, I broke the clips apart from the injectors. (Looking back I should have just cut the wires and resoldered).
Anyways, I ordered used gsr obd1 injectors and clips off of ebay. All the injectors have two wires coming off them, one is a ground which is black and yellow. two injectors have yellow wires with the ground, while the other two have brown wires along with the ground. BUT..... My wire harness has the black and yellow grounds along with a Brown, Red, Blue, and Yellow wire from injector 4 to 1.
Does the order of injector matter? Or can I just solder together ground to ground, and colors to colors. (ex: blue to yellow) Thanks for the help! and sorry for the long post if its confusing
Anyways, I ordered used gsr obd1 injectors and clips off of ebay. All the injectors have two wires coming off them, one is a ground which is black and yellow. two injectors have yellow wires with the ground, while the other two have brown wires along with the ground. BUT..... My wire harness has the black and yellow grounds along with a Brown, Red, Blue, and Yellow wire from injector 4 to 1.
Does the order of injector matter? Or can I just solder together ground to ground, and colors to colors. (ex: blue to yellow) Thanks for the help! and sorry for the long post if its confusing
#2
Honda-Tech Member
Thread Starter
Join Date: Mar 2011
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Re: OBD1 Injector Wiring Help
The thing is, the ebay item I purchased clearly shows a brown, red, blue, and yellow wire but I got two browns and two yellows. Am i out of luck wiring them in?
Thread
Thread Starter
Forum
Replies
Last Post