GreenTeaLS

Hello Honda-Tech Community, i have 1997 Acura Integra LS Sedan , my license plate (rear) bulbs just went out, i noticed it last night, can someone tell me whats the type of bulb that the license plate needs, Thanks Guys

SiR AuToBoT

go to autozone, kragen
and ask them they could help you out right there
and get the bulbs at the same time.

JustAnotherG20

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by CypressGreenLS &raquo;</TD></TR><TR><TD CLASS="quote">Hello Honda-Tech Community, i have 1997 Acura Integra LS Sedan , my license plate (rear) bulbs just went out, i noticed it last night, can someone tell me whats the type of bulb that the license plate needs, Thanks Guys </TD></TR></TABLE>

From the T-I article they should be 168 or 194 (same size, but one is brighter than the other).

95gsrteg

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by total_noob &raquo;</TD></TR><TR><TD CLASS="quote">

From the T-I article they should be 168 or 194 (same size, but one is brighter than the other).</TD></TR></TABLE>

is it really a 194? the same wedge bulb that goes in the front corner? because i think i took a look and the factory one is a bit bigger in size........but the 194 wedge will fit in there. i just don't know if it'll be brighter or not than the factory one.

SPR876-B18C1

so i tired to change my bulb .. but on pulling out the light i realized there was no bulb in it and no connections ..

so im jus wondering now .. after i buy a bulb how do i go about getting the light to work .. i see some wires inside the trunk on the left hand side panel .. is it that i am goin to have to pull off the back bumber and run a connection from that wire im seeing to the licence plate light ..

sounds like alot

G-Weezy

The wire goes up through the back plastic panel in the trunk. Remove that panel and you will see a connection plug there.

I wired LED's to that source and fed the line through the same holes the wires are running through. Mounted the LEDS in the brackets.

fcm

Good luck removing anything to do with the licence plate bulbs, bulb lens or bracket.

Spray with a release agent, [MoveIt] before attempting to remove any phillips screw, they will be rusted and you will strip the heads if not real careful.

It is a 168 bulb. [12V 8W]. 94

SPR876-B18C1

ok kool was thinking that might be it .. gonna do that asap

already took them out .. with just the phillips