Goy091

https://honda-tech.com/zerothread?id=209450

here guys can ya help me out?


tia

3rdgengsr

If you're installing in a 2 door have fun! You pretty much have to remove everything from the doors back, including your whole seats, the panel that covers your tailights, its a real pain.

1hotintegra

you really dont have to take anyting out. i replaced mine just by taking off the cover of the speakers

acteg94

thats tru .. all u have to do is pop the speaker covers out ... simple ... and easy ..

cannan

I tried just removing the speaker grill, it was a pain in the *** getting the stock speaker out. Its much easier removing the rear seat and all the paneling. It really isn't that hard, must of it just pops in and out

Goy091

haha ok guys thanks, i just ripped it ALL out haha that was fun, i dont get why ppl want to strip their cars if theyre not tracked. the pieces only weighed mebe 20lbs? heh to each his own.

thanks

samagon

this is exactly what I did, but do it with care, you could break the plastic, but it is very possible to do this without any problems.

sutrusu

silly integra owner. who needs an interior?

TEG98

In my 2 door I didn't remove the plastic completely. Simply cut the foam pilar forward of the rear speakers, and have a friend pull out on the interior panel (after you remove the screws holding the panel in) Maneuver the speaker in. Finally use some duct tape and glue to repair the pilar.

Volcom

Since I put in oversized 6.5's I took out the entire plastic side piece. I also ran new 12 gauge wiring to the rear speakers to the amp. It wasn't too bad taking everything out.