gofastgokart99

I searched, found nothing that helped.

A few nights ago I backed my car up a tad too close to a parking curb and pushed/bent the axle back section on my APEXi N1 to the point that it is now resting against underside of the car, actually making contact. Its not pinched but does have a nice dent from hitting the sway bar. I managed to get it back on one of the hangers so it isn't completely suspended by the hangers in the middle of the car.

The current axle-back was already in rough condition and I was planning on replacing it soon any way.

My question is this: Can I replace my N1 axle back with a WS2? It it simply bolt right up and be the proper length? I like the way the N1 sounds but it does not look that great and will not be angry if the WS2 changes the sound or quiets it down, in fact I welcome it.

Car is a 99 LS 5spd btw if that helps.

Is this simply something I should contact APEXi USA about?

Thanks,

Garrett

jonyi27

Look up some vids on how it sounds, to see if you like it

gofastgokart99

I know how they sound, quieter,and they look better. The question is will the WS2 bolt up to the current B pipe?

Gsrsi

If they don't you can cut an weld a flange or just weld it together.