I'm trying with one to see if it works

 

ok more pics...




pics of the parts coming soon.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by joey1320 &raquo;</TD></TR><TR><TD CLASS="quote">ok more pics...




pics of the parts coming soon.</TD></TR></TABLE>

Good **** what are your plans for it

 

these are some of the parts that I'm putting on...
SRP pistons
Eagle rods
Centerforce clutch
JE rings
ARP bolts
plus everything else new... bearings/water pump/timing belt...

And for anyone putting a ZC together, the rods might hit the cilynders so some small modifications are needed... I just found out yesterday!

 

good luck

 

what vdub bolts did you get?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by dj_sandoz &raquo;</TD></TR><TR><TD CLASS="quote">what vdub bolts did you get? </TD></TR></TABLE>

ARP now makes em for the ZC.

 

Did you hone those cylinder walls?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by sporkcrx &raquo;</TD></TR><TR><TD CLASS="quote">Did you hone those cylinder walls?</TD></TR></TABLE>

I didn't know I had to so I'll be doing that tomorrow, thanks...
I should had asked before.
I'm getting the turbo tomorrow also for 150$.
T5/injector/smic/bov

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by joey1320 &raquo;</TD></TR><TR><TD CLASS="quote"> And for anyone putting a ZC together, the rods might hit the cilynders so some small modifications are needed... I just found out yesterday!</TD></TR></TABLE>

you will have to notch the block to get those rods to not hit. there are some pics on http://www.theoldone.com. check them out.

also, i highly recommend getting a service manual if you are doing a rebuild. not knowing you need to do a honing shows me you need to do some research before doing this rebuild. i'm not trying to be an ***, just trying to help out.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by keithv &raquo;</TD></TR><TR><TD CLASS="quote">

you will have to notch the block to get those rods to not hit. there are some pics on http://www.theoldone.com. check them out.

also, i highly recommend getting a service manual if you are doing a rebuild. not knowing you need to do a honing shows me you need to do some research before doing this rebuild. i'm not trying to be an ***, just trying to help out.</TD></TR></TABLE>


I actually got the manual, and I asked plenty of times about the build up and no-one ever mentioned this before. Thanks for the help tough.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by drjondurst &raquo;</TD></TR><TR><TD CLASS="quote">

ARP now makes em for the ZC.</TD></TR></TABLE>
What's the part # for them, i need some. Thanks