First off i did a search, i'm really not sure whether i'm going b18a/b/c i guess it really depends on whats available however, would i pretty much need these same parts to get it into my 89?

The engine obviously
y1 Teg tranny
90-93 Teg axles
Hasport mount kit and adjustable shift linkage...

and thats really all i know about...i want to know if there is a better way to do this? what other parts do it need? also what about the ECU? i'm running obd1 with a p28 can i just convert that or should i get the ECU that corresponds to the engine???

sorry these are a lot of questions but i really need to know what i'm going to get myself into..i don't want any suprises.

 

haaaaaaaaaaaaaaaaaaaasporrrrrrrrrrrrrrtttttttttttt tt.com

http://www.hasport.com/Tech/Installs...0partslist.htm


[Modified by SteveeeO, 8:25 PM 1/6/2003]

 

i need a parts list too..this is what i got so far place racing motor mounts, axles, shift linkage, 5 speed trans, ls computer, wire harness...do i need any thing else..this is for a HF crx

ohh yea and if i were going to use the teg axles would i need to use teg hubs to are can i just use my stocks??

 

What are you swapping this into, 89 what? It will affect your parts list.
If you allready set up for obd1, you'll be fine. I'm running obd1 with a chipped p28 in my swap.

Just don't forget the little stuff, like timing belt new plugs and wires things like that. Also don't forget the rear tranny mount, you'll need that too. Good luck, and if you have any specific questions feel free to ask.

 

you need money .. you have to buy lots of little things here and there but it all adds up.. just have cash on hand.